Patio Door Handle Repair Near Me

Handles for patio doors are a key element of any sliding patio door repair company near me door, and they come in a wide variety of styles that will fit your decor. The handles are usually comprised of two parts: the inside handle and the exterior. They are joined by spindles. It is not as hard as it may seem to replace the handle of a patio door.

Fixing a loose knob

Over time, your uPVC patio door will see a lot of use and can start to feel wobbly or loose. It is essential to fix the handle immediately to restore smooth operation to your patio door. This will reduce air leaks, reduce energy consumption and also prevent further damage to the track of your door.

It's not as difficult as you think to fix loose handles on your patio. It's just a matter of following a few easy steps. First, you will need to locate the screws that keep the interior handle in place. You will find them on the interior of the doors. You'll you will need to remove them with the aid of a screwdriver.

After you've removed the screws, you will be required to measure the back plate fixing centres as well as the pz centre of the spindle hole. These measurements will help you determine the diameter of the new handle. Also, ensure that it is snugly fitted. This is a simple process that shouldn't take longer than 10 minutes.

Replace a Broken Spindle

Sometimes, a handle breaks completely or be damaged to the point that it requires replacement. The good thing is that replacing the handle set for a patio door is fairly simple for most homeowners and does not require specialized tools. The basic process consists of replacing the exterior and interior handles along with the spindle that connects them.

If you can first, you'll need to figure out the cause of the broken handle. If you hold the collar or the base of the knob, you will be able to see if it spins independently. This will allow you to determine if the issue is with the knob or the collar that is broken.

Set screws can be used to tighten the collar when it is loose. This screw is usually found within the door, just behind the collar. If the spindle has broken, you will need to remove the collar and replace it. It is possible to find a handle set compatible with the hardware you currently have based on the style of your door. This can save you time and money as well as a lot frustration.

You can also replace the whole door handle. If you decide to do this remove the latch's internal mounting screw and pull the door handle off. Then, you'll need to remove the screws and screw in the new handle. You'll need to close and open the door several times to verify that the handles are functioning correctly.

If you're not sure about changing your handle or if the issue isn't resolved with other options then you can always walk to Hippo to discuss your concerns with us. We'll be able to find the correct replacement handle for your needs, and ensure that it's a good fit. We can also help you select the right handle set for your home according to hole spacing and thickness, as well as the position of your thumb latch. This can ensure that your new handle is a perfect fit to your patio door!

Replacing a damaged Handle

It is important to be aware of a few points before you replace the handle on your patio door. These include the tools you'll require and the steps to take. The first step is to remove the interior handle. You can remove the two screws holding it in place by lifting up the door and then removing it from its track. You can then install the new handle after you have removed the handles.

Installing a new handle

Replace a patio door handle if you've lost it or want to update its appearance. It is a relatively easy DIY project. The handle is comprised of two parts, an inside and exterior handle that are joined to spindle (a rod of steel that is located in the middle of the door). First, remove the screws that secure the handle in the interior. After the screws have been removed you can open the door, pull it up and you will find the exterior handle. It is secured by another set of screws. The next step is to remove the old handle and replace it with the new one. You may also need to replace the spindle that was used previously if it is damaged or broken. Then, screw the new handle into place and close the door to the front.